Blown In Insulation in Van Nuys — Same-Day Service, Done Right the First Time

Trusted Blown In Insulation for Van Nuys Homeowners

Blown In Insulation in Van Nuys is the most direct way to stop the heat in your attic from turning every room into an oven by 2 p.m. most homes in Van Nuys were built between the 1940s and 1970s, which means the original attic insulation is either settled, vermin-soiled, or was never sufficient for our summer peaks. Thermal Insulation Co installs loose-fill fiberglass and cellulose using calibrated blower equipment, and we’re the only insulation-only contractor serving Van Nuys with eight material brands and three installation methods in-house. If your attic floor shows exposed joists or your upstairs runs 10-plus degrees hotter than downstairs, call us at (855) 382-3451. We come out, inspect the attic, and give you a real number before any work starts.

Call (855) 382-3451

Cellulose Insulation

Cellulose Insulation is a loose-fill material made primarily from recycled paper stock treated with fire-retardant boric compounds, and we install the GreenFiber line across Van Nuys, Encino, and North Hills. It performs better than fiberglass at stopping air movement because it packs more densely, which matters in older Van Nuys attics where gaps around recessed lights and framing let conditioned air escape. We recommend cellulose for attics with irregular joist spacing, shallow cavities, or existing insulation that just needs a thermal top-up. You will pay roughly $1.40 to $2.10 per square foot installed for blown cellulose in a typical Van Nuys attic, or about $1,650 to $2,600 for a 1,200-square-foot attic.

Air-Stopping Performance

Cellulose settles into the small gaps where fiberglass batts leave voids, reducing the stack effect that pulls hot attic air into living space. In Van Nuys ranch homes with multiple ceiling penetrations, that air-sealing benefit often matters more than the nominal R-value.

Recycled Content and Moisture

GreenFiber cellulose runs roughly 85 percent post-consumer recycled content, which appeals to homeowners who care about material sourcing. We still inspect for roof leaks before installation, because cellulose absorbs water and loses R-value faster than fiberglass if a leak develops.

Blown In Attic Insulation

Blown In Attic Insulation is loose-fill material mechanically distributed across the attic floor to create a continuous thermal layer, and it is the method we install most often for Van Nuys homes built before 1980. The point is coverage: blown fibers settle around pipes, wiring, bracing, and odd framing angles that batts leave exposed. Attics in Van Nuys neighborhoods like North Hills and North Hollywood routinely measure R-11 to R-19 when current code suggests R-38 or better for the San Fernando Valley climate zone. For a standard 1,200-square-foot attic, blown in attic insulation in Van Nuys runs $1,500 to $2,800 depending on material choice, R-value target, and access conditions. We install in a day.

The Coverage Problem Batts Can’t Solve

Fiberglass batts leave seams at every joist and around every truss chord. A blower hose drops loose-fill into those seams, and the result is a thermal blanket with no intentional gaps.

When Attic Access Is Tight

Van Nuys attics with a scuttle hole in a closet ceiling, a low-pitch roof, or HVAC ductwork crowding the floor are hard to blanket with batts. Blown in material goes through a 4-inch hose, which means we can insulate attics that would otherwise require cutting drywall.

Blown In Cellulose Insulation

Blown In Cellulose Insulation is loose-fill recycled paper insulation installed with a blower, and Thermal Insulation Co uses GreenFiber for these jobs throughout Van Nuys, Sherman Oaks, and Studio City. It is our recommendation when the priority is reducing air leakage, not just adding R-value, because the dense pack of cellulose fibers slows airflow far better than a batt. A typical blown in cellulose insulation project in Van Nuys costs $1,650 to $2,600 for 1,200 square feet, or $1.40 to $2.10 per square foot on average. The material settles about 10 to 15 percent after install, so we calculate settled thickness up front rather than just blowing to the marked line, and in Van Nuys that means accounting for our summer heat as much as our winter nights.

Borate Fire Treatment

The boric compound in GreenFiber cellulose is there for fire resistance and to deter insects, not as a selling gimmick. It is tested material, and it gives an additional margin in old Van Nuys attics with outdated wiring.

Cellulose Over Existing Insulation

If your attic has an old, thin layer of fiberglass that settled two decades ago, we can blow cellulose directly over it. The existing layer stays in place, the new material adds thermal mass, and the result is a deeper combined depth than most single-material jobs.

Blown In Fiberglass Insulation

Blown In Fiberglass Insulation is loose-fill fiberglass distributed with a blower, and we install Owens Corning and Johns Manville products for this method in Van Nuys, Valley Glen, and Northridge. Fiberglass loose-fill has better moisture resistance than cellulose, which matters in attics where roof flashing is old but not yet leaking, or where condensation from bathroom vents has been a problem. It also weighs less per square foot of installed coverage, so in attics with 2×4 ceiling joists and older drywall, it puts less load on the structure. In Van Nuys you should expect $1.20 to $1.90 per square foot for blown fiberglass, or $1,500 to $2,400 for a 1,200-square-foot attic brought up to R-38.

Choosing Fiberglass Over Cellulose

We recommend blown fiberglass when the attic is dry, well-vented, and the homeowner wants the lower weight and simpler future removal. It does not settle the way cellulose does, so depth stays closer to what we blow.

Older Homes and Joist Spacing

Van Nuys houses from the 1950s and 1960s often have 16-inch on-center joists but a lot of cross-bracing and electrical work running through the attic. Blown fiberglass handles that clutter better than batts, and it is the material we default to when the attic will be accessed again for HVAC work.

Loose Fill Insulation

Loose Fill Insulation is any insulation product installed by blowing or pouring material into an attic cavity, and in Van Nuys that means either fiberglass or cellulose from the brands we carry. It is the right call when the attic floor is uneven, the existing insulation has settled, or the homeowner wants a fast upgrade without removing old batts. Typical loose fill insulation installation in Van Nuys runs $1.20 to $2.10 per square foot depending on material and depth, which translates to $1,500 to $2,700 for a 1,200-square-foot attic. We remove or contain old material when needed, air-seal the major penetrations, then blow to a measured, settled R-value rather than guessing at depth.

Settled Thickness and R-Value Math

Loose fill loses some installed height as it compresses, and different materials settle differently. We blow to the depth that yields the settled R-value you paid for, which is why our quotes state the target R-value, not just the number of bags.

Overthinking the Method Decision

Most homeowners do not need to choose between loose fill types before we inspect the attic. We look at joist depth, existing insulation, air leaks, and then tell you which material and method gets the best result for the money.

Blown In Insulation Contractors

Blown In Insulation Contractors specialize in the equipment, material knowledge, and attic access techniques needed to install loose-fill properly, and in Van Nuys that specialization matters more than most people assume. A general contractor with a rented blower from the hardware store produces a job that looks fine on the surface and fails in the first summer heat. We are an insulation-only contractor, which means every day is spent in attics and walls, not splitting time across bathrooms and kitchens. The cost for hiring insulation contractors in Van Nuys runs $1,500 to $2,700 for a typical attic, with the labor portion often lower than a homeowner expects because a professional crew works fast and does not waste material.

What Specialization Changes

A dedicated insulation crew spots problems a generalist misses: inadequate venting, knob-and-tube wiring that needs to stay clear of insulation, recessed light housings that need rated covers. Those issues are part of the job here, not a surprise discovered halfway through.

Single-Trade Contractors vs. Generalists

We carry Owens Corning, Johns Manville, GreenFiber, and Rockwool because different Van Nuys attics need different materials. A general contractor carrying one brand sells you that brand. We sell the material that fits your envelope.

Brands We Service

We install and service GreenFiber cellulose because it gives us a recycled-content option we can honestly recommend for air-sealing performance in older Van Nuys attics. The borate treatment and dense-pack behavior of cellulose make it the right tool for certain jobs, and having it in the truck means we’re not forcing a fiberglass solution when cellulose is the better call.

We carry Owens Corning and Johns Manville loose-fill fiberglass because between the two, we can match the moisture-resistance and weight characteristics almost any Van Nuys attic needs. Whether you have an attic full of old Owens Corning that settled, or a Johns Manville batt job from a previous owner that left gaps, we can repair or top it up. Whether you have GreenFiber, Owens Corning, Johns Manville, or any other make already in place, we can help.

Signs You Need a Pro Right Now

• Upstairs rooms run 8 degrees hotter than downstairs by mid-afternoon. That differential is heat loading through the attic, and it is the most common call driver in Van Nuys. The attic becomes a heat chamber that re-radiates into living space after the sun goes down.
• You can see the tops of attic joists. If joists protrude above the insulation, the effective R-value is far below what the original rating suggests. Exposed framing is thermal bridging that lets heat and cold pass through unconditioned.
• Energy bills in July and August spike while winter is mild. In Van Nuys, cooling is the bigger cost driver and under-insulated attics are why AC runs continuously. A deeper attic layer is typically the highest-ROI upgrade for summer bills.
• Rooms over the garage feel like a different climate. Garage ceilings are often skipped by original builders, leaving zero thermal barrier between your car and your living space. We correct that with blown in material in a single visit.
• Existing insulation looks damp, matted, or has dark streaks. Darkened insulation usually means air has been moving through it, filtering dust and moisture. That is a performance problem and a sign the attic needs air-sealing before new material goes in.

Our Process, Step by Step

1. 1
   Inspection and measurement. We inspect the attic, measure square footage, check joist depth, existing insulation depth and condition, and look for air leaks, wiring, and venting issues. We use a thermal imaging camera on request to locate heat bypasses that visual inspection misses.
2. 2
   Material and R-value recommendation. Based on the attic’s condition and your goals, we recommend cellulose or fiberglass and the target R-value. We tell you why we are recommending that material, and what the alternative would cost.
3. 3
   Air sealing and prep. Before blowing any material, we seal the major penetrations: plumbing stacks, wire drops, can light housings with rated covers, and the access hatch. Insulation without air sealing is only half the job.
4. 4
   Blown installation. We run the blower from the truck, feed material at a controlled rate, and check depth against marked gauges throughout the attic. The goal is even coverage with no thin spots at eaves or around trusses.
5. 5
   Post-install verification. We document the finished depth, confirm the settled R-value meets the target, and walk you through what was done. If you want before and after photos, we provide them the same day.

How Much Does Blown In Insulation Cost in Van Nuys?

Our Service Area Near Van Nuys

Thermal Insulation Co covers Van Nuys and the surrounding San Fernando Valley: Valley Glen, Sherman Oaks, Encino, Studio City, North Hills, North Hollywood, Northridge, Universal City, San Fernando, Shadow Hills, and Burbank. We can typically reach any of these areas from our Van Nuys base within 24 to 48 hours for an estimate, and same-week installation is common outside peak summer. If you have a blown in insulation need in Valley Glen or want to compare Sherman Oaks service pricing, we can help. Our home page has the full service overview.

Frequently Asked Questions About Blown In Insulation in Van Nuys

Schedule Your Blown In Insulation Service in Van Nuys Today

If your Van Nuys attic is under-insulated, getting a real inspection and a written quote costs you nothing. Call (855) 382-3451 and we will schedule a time to walk the attic, measure, and tell you exactly what material and depth your home needs, with no pressure and no vague estimates. Summer is coming, and the best time to fix a hot upstairs room is before the first heatwave, not during it.

Written by Ruben Castellano, Owner at Thermal Insulation Co, serving Van Nuys and the San Fernando Valley.